Only Specified State

Owned by liyahui (Unlicensed)
Jun 08, 2022
2 min read

Only Specified State : That is, this action can be displayed only in the specified state (applicable to the case where multiple states point to the same state through an action, including reuse transitions).

Workflow Example :

 

(1) Click 'Add condition'

 

(2) Select “Only Specified State” and click Add

 

(3) Select the state

Note: Assuming that the sending state of the action is the source state and the receiving state of the action is the target state, then the selected state at this time will only be displayed if it is the source state of the current action, otherwise it will not be displayed.

 

(4) After the addition is successful, the page displays "This action is displayed when the current status is **."

 

(5) Open the issue,

① If the current issue status is "unselected source status", this action will not be displayed

 

②If the current state is "selected source state", the action is displayed at this time

 

③ If the current state is the selected state, but it is not the source state of the specified action, then even if this state is selected, the action will not be displayed on the issue